strain distribution

The results show, after two passes through route B_A and B_C, the sample strain distribution turns to be inhomogeneous, and shear deformation mainly concentrates on cross position of two passes shear surface.

研究结果表明，采用路径B A、B C两道次挤压后，试样横截面内部的应变分布不均匀，剪切变形主要集中于两道次的剪切面的交叉处。

Strain Distribution Curves for Cement Concrete under Axial Compression

水泥混凝土轴心受压应变的分布曲线

The results show the strain distribution of soft tissues is imaged and compared with corresponding B-mode images, and the elastic properties of target tissue which can not be acquired from B-mode images are detectable by the system described in this paper.

实验结果表明，该应变成像系统在获得传统B型超声图像的同时，可以获得组织内部的应变分布图像，从而获取在B超图像上无法得到的组织弹性变化。

Objective : To analyze the strain distribution of bone around the single-implant-supported fixed prosthesis.

目的: 研究负荷对单个种植牙的种植体边缘骨的应力影响.

Then it compared the stress distribution and strain distribution of blades which is orthotropic material.

并比较了各向异性材料叶片的模态应力和模态应变的分布状态.

The curve of strain distribution was drawn through computing the strains with Euler coordinate system.

采用Euler坐标进行应变的计算分析，绘出了孔洞周围应变分布曲线。

Based on the linear strain distribution assumption, strain development of tensile bars and ultimate moment capacity of strengthening section, which strengthened on tension side with service load un removed, is investigated.

本文以应变平截面假定为基础，对非卸载条件下受拉区加固梁截面的钢筋应变发展及抗弯承载力的发展进行分析研究。

Analyses of Expression and Distribution of GFAP and NSE at the Terminal Stage in the Brain Tissues of the Hamsters Infected with Scrapie Strain 263K

羊瘙痒因子263K感染仓鼠终末期脑中胶质纤维酸性蛋白和神经元特异性烯醇化酶的表达和分布变化研究

Then, a simple test plate is designed by the stress strain distribution on the bellows expansion joints.

应用非线性有限元获取波纹管的最大局部应力应变，并据此局部应变设计简化的试板。

Dynamic plastic strain distribution around propagating cracks emanating from a circular hole

圆孔边缘裂纹扩展过程中裂纹周围的动态塑性应变测量

This was further proved by the discrepancy between practical and theoretical misorientation distribution. The discrepancy was explained by strain accommodation mechanism.

实际取向差分布特征与理论情况的差异也证明了这一点，使用应变补偿机理解释了这一差异。

According to the whole-field displacement and the strain distribution under seven grade load, two dimension strain changing trend under eccentric load and variation coefficient trend, we can distinguish its linearity and average stress when tiny crack occures.

结果表明：在7级载荷下测试获得全场位移、应变分布及消除加载偏心影响后的二维应变和变异系数变化趋势，可区别其线性、非线性及发生微裂纹贯通阶段的平均应力。

By testing strain distribution and calculating bond shear with complete anchorage between steel and concrete and by comparing the bond shear with the actual bond strength, it is concluded that bond failure and slip take place between steel and concrete.

根据实测应变分布，计算钢筋与混凝土在完全锚固情况下的粘结剪力，并与混凝土对钢筋的实际粘结强度进行比较，得出钢筋与混凝土粘结破坏并产生滑移的结论；

It can be found from the analogous that the Thermal Strain distribution of sidewall under different conditions differs a lot.

由模拟情况得知，不同工况下侧墙的温度应变分布差异性很大。

The measurement of tensile strain distribution of optical fiber is very necessary to guarantee the long-term reliability of optical cable.

通信光缆拉伸应变分布测量对于保证光纤通信线路的长期可靠性具有十分重要的意义。

In the process of deep-drawn strain test for CR 304 stainless steel plates, the strain distribution law in each area of the deep-drawn parts, the martensitic transformation analysis, wall thickness and history of hardness change are carefully studied through using martensitic transformation analysis method.

应用马氏体转变分析方法，对304不锈钢冷轧板拉深应变试验过程中拉深件各个区域的应变分布规律、马氏体转变分析、壁厚、硬度变化历史进行了研究；

Screw method for measuring strain distribution in metal plastic deformation body

用嵌入螺柱法测量金属体内塑性应变分布

Base on the basic theory of finite-element analysis, hypostatic modeling for four-side simple supporting plank was upbuilt with ANSYS software. Three-dimensions hypostatic model and plane model were present by simulating the strain distribution of four-side simple supporting plank with damage using finite-element analysis software.

介绍了有限元分析的理论基础，用ANSYS软件对四边简支板试件进行了实体建模，比较了三维实体模型和平面模型特点，并指出了采用平面模型进行建模的合理性；

Influence of Elastic Modulus of Adhesive on the Stress and Strain Distribution in Aluminium Single Lap Joint

胶粘剂弹性模量对铝合金单搭接接头应力应变分布的影响

And decreasing the angle can distribution of the strain and prevent riveting cracks in rivet tail.

减小铆模倾角可以减小最大剪应力,从而减小剪应变,防止镦头裂纹的产生.

Commonly, ultrasound elastography can only obtain the axial strain distribution of tissues with an external compression.

超声弹性成像通常只能得到组织在外部压缩作用下的纵向应变分布.

After decreasing weld-bead movement, the formability of tailor-welded blanks is greatly improved according to the forming limited diagram, stress distribution, strain distribution and thickness thinning.

通过减少焊缝移动量，在成形极限图、应力分布、应变分布和厚度减薄率这四个方面改善拼焊板的成形性能。

Using ANSYS stress analysis software to simulate actual stress and strain distribution of test pieces, and then cloud picture and distribution curve is obtained.

使用ANSYS应力分析软件对试件的应力、应变分布进行仿真，得到了仿真云图及分布曲线。

Study on Dentification Ability of Inbred Strain Mice Tooth Germs Implanted into Oral Submucosa and Alveolar Process AIM: To analyze the distribution of initial stress around screw implant.

近交系小鼠牙胚同种异体移植至口腔粘膜下或牙槽骨内成牙能力的研究目的：分析螺旋形种植体植入下颌骨后骨界面初始应力的分布。

Digital image correlation method ( DICM) was used to investigate the full-field displacement and strain distribution in concrete under fatigue loading, emphatically analyzed the displacement and strain when the concrete crack appeared.

采用数字图像相关方法（DICM）研究了在疲劳荷载作用下混凝土表面的位移场及应变场分布，并着重分析了混凝土在裂缝出现前后的位移、应变变化。

From the specimen in cross-sectional view of the central and the equivalent strain along the inside corner to the lateral direction, the strain distribution is uneven. Through analyzing numerical simulation results and the deformation of the samples after the morphology and microcosmic comparison, simulation was effective.

通过数值模拟结果和变形后试样的形貌及微观组织进行对照，验证了模拟的有效性。

This research demonstrate that photo-plastic material memory faculty is confident to define plastic deforming strain distribution.

研究表明,利用光塑性材料记忆性确定塑性变形的应变分布是可靠的.

The experiment is based on the reinforced retaining wall structure of whole rigid panel, working mechanism of reinforced flyash retaining wall, strain distribution of tensile reinforcement, deformation of reinforced flyash retaining wall are researched.

试验基于整体刚性面层加筋土挡墙结构研究了粉煤灰加筋土挡墙的工作机理、筋材中的应变分布、粉煤灰加筋挡墙的变形。

Simulation Test on Strain Distribution at Crack-Tip adjacent to Interface of Dissimilar Materials

异种材料结合界面附近裂纹尖端处应变分布的模拟试验研究

The principle of Brillouin optical time domain reflectometer ( BOTDR) is introduced and its application to the strain monitoring of the strain distribution of the reinforced concrete beam is studied.

介绍了布里渊光时域反射计（BOTDR）的分布式光纤应变测量原理，并应用BOTDR技术对钢筋混凝土T型梁加载后的应变分布进行了测量。